User's Manual

Ruckus Wireless ZoneFlex 2925/2942/7942 User Guide | Installation, Setup, and Placementof the AP
7
2942/7942 Features
The following illustration shows the side view of a ZF2942/ZF7942 AP, highlighting the four
LED indicators that can be used to assess both device and network status.
FIGURE 2-3: Side view
[1] OPT
[2] DIR
[3] AIR
[4] WLAN
[5] Hard Reset: Pushing this internal but-
ton and releasing quickly reboots the AP.
Holding it for 6 seconds resets the AP to
factory defaults.
For more information on what each LED’s
lights may indicate, see the “LED” table
below.
LED If you see this... This is happening...
Power • If this LED is steady green . . . . .
• If off . . . . . . . . . . . . . . . . . . . . . .
• Power is ON.
• No power is connected.
OPT N/A Optional feature. Not active in this model at this time.
DIR • If this LED is steady green . . . . .
• If this LED is steady green for 2-3
seconds . . . . . . . . . . . . . . . . . . .
• If flashing green . . . . . . . . . . . . .
• If off . . . . . . . . . . . . . . . . . . . . . .
• Communication between Director and AP is up.
• The AP is booting up.
• Communication between Director and AP is down.
• AP is not under Director control.
AIR • If off . . . . . . . . . . . . . . . . . . . . . .
• If blinking red/amber alternately .
• If blinking red/green alternately .
• If flashing green . . . . . . . . . . . . .
• If steady green . . . . . . . . . . . . . .
• There is no station associated.
• AP is booting up.
• Wireless data traffic is unreachable.
• Wireless data traffic is reachable.
• Good air quality.
1
2
3
4
5