User's Manual

Ruckus Wireless ZoneFlex 2925/2942/7942 User Guide | Managing the Access Point
48
• VLAN port state icons: "Member VLAN ports" allow the network’s traffic to flow through
it's associated RJ45 connector. If that port is configured for VLAN-tagging, then the
"tagged member VLAN port" icon will be displayed. A "non-member VLAN port" does not
allow network traffic to flow through the RJ45 connector.
Clicking an icon toggles that VLAN port between "member" and "non-member" status. The
port may automatically be marked as "tagged" where appropriate.
• Show me an example: Clicking on the button labeled Show me an example opens a
few sample configurations, with an explanation of what each shows. See “VLAN configu-
ration examples” on page48.
• Update Settings (test): When you click Update Settings (test), if any configuration
settings changed, a connectivity-test will be run; this lasts approximately 30 seconds. If
the browser and the AP/Router can communicate with the new VLAN settings, then they
will remain set. If connectivity fails, then the device will revert to the previous VLAN set-
tings. A pop-up message will tell you whether the test passed or failed and VLAN values
were reverted.
• Update Settings (no testing, override): When you click Update Settings (no test-
ing, override), you are saving configuration changes without a connectivity test.
VLAN configuration examples
Default Configuration
By default, the Management network and all WLANs are mapped to the same VLAN and are
available untagged on all ports.
VLAN Separation
In this example, each wireless LAN (wlan#) is mapped to a different VLAN (e.g., wlan0 is
mapped into VLAN 11). All of these WLANs are available on the WAN port where the Manage-
ment network is untagged and the rest of the VLANs are tagged.
The Management network is available untagged on all ports.
Tagged
port
Untagged
port
Member
VLAN port
Non-member
VLAN port
Tagged member VLAN port