User's Manual

Ruckus Wireless ZoneFlex 2925/2942/7942 User Guide | Managing the Access Point
54
Restoring the AP to Factory Default Settings
You can use the Web User interface to restore an inoperative AP to its factory default set-
tings, which will completely erase the configuration currently active in the device. Note,
too, that this will disrupt all wi-fi network communications through this device.
After restoring the factory default state, you can reset the AP to match your preferences, as
detailed in “Installation, Setup, and Placementof the AP” on page4.
1 After logging into the Web User interface, click Reboot/Reset under Maintenance
The Maintenance::Reboot/Reset workspace appears.
2 Review the options.
3 Click Reset now (by Restore to factory settings).
After a brief pause, you will be automatically logged out of the AP.
You must now disconnect the AP from the switch (and the network) and re-connect it
to your computer, as described in “Installation, Setup, and Placementof the AP” on
page4. At this time, you can restore the network settings, then replace it in your site
for full network use.
ALERT!
DO NOT DO THE FOLLOWING unless you are directed to do so by Ruckus Wireless sup-
port staff or by a network administrator. Do this only if you are able to immediately reconnect
the restored AP to your computer, to reconfigure it for wi-fi network use—as detailed in
“Installation, Setup, and Placementof the AP” on page4.
FIGURE 4-9: