Installation Guide
Table Of Contents
- Contents
- 1 About this Installation Guide
- 2 Planning the SC8800-S AP Installation
- 3 Preparing the SC8800-S AP at the Depot and Shipping to the Field
- 4 Installing the SC8800-S AP in the Field
- Installation Components and Constraints
- Deploying the Access Point
- Mounting the Access Point
- Mounting the U-Joint Bracket to the Main Mounting Bracket
- Attaching the Main Mounting Bracket to a Flat Surface
- Attaching the Main Mounting Bracket to a Wooden Pole
- Attaching the Main Mounting Bracket to a Metal Pole
- Mounting the Hook Bracket to the U-Joint Bracket
- Assembling the AP Attachment Bracket and the Access Point
- Attaching the AP Attachment Bracket and AP to the Hook Bracket
- Safety-Cabling the AP
- Mounting External Antennas (Optional)
- Verifying Access Point Operation
- 5 What to Do Next
- Appendix A: Ruckus Wireless-Supplied and Customer-Ordered Parts
- Appendix B: Resetting the Access Point to Factory Default Settings
- Appendix C: Installer Mounting Dimensions
19
Preparing the SC8800-S AP at the Depot and Shipping to the Field
Configuring the AP for Management by FlexMaster or for Standalone Operation
Connecting the AP to the Administrative Computer
1. Verify that the AP is powered on as described in “Powering the AP” on page 14.
2. If you are powering the AP with PoE, then continue with Step 3. If you are powering
the AP with AC, then continue with Step 6.
3. Connect one end of the Ethernet cable to the Data In port on the PoE injector.
4. Connect the other end of the Ethernet cable to the administrative computer either
directly or through a hub.
5. You have completed connecting the AP to the administrative computer. Continue with
“Logging In to the Access Point’s Web Interface”
on page 19.
6. Connect one end of the Ethernet cable to the PoE IN port on the AP.
7. Connect the other end of the Ethernet cable to the administrative computer.
8. You have completed connecting the AP to the administrative computer. Continue with
“Logging In to the Access Point’s Web Interface”
on page 19.
Logging In to the Access Point’s Web Interface
1. In the address or location bar, type the following address:
https://192.168.0.1
2. Press <Enter> on the keyboard to connect to the AP’s web interface. A security alert
message appears.
3. Click Yes or OK or Proceed anyway (depending on the browser) to continue. The AP’s
login page appears.
Figure 11. The ZoneFlex Access Point login page
4. In Username, type super.
5. In Password, type sp-admin.
6. Click Login. The web interface appears, displaying the Status > Device page.
7. Continue with “Configuring Common Wireless Settings”
on page 20.