Installation Guide
Table Of Contents
- Contents
- 1 About this Installation Guide
- 2 Planning the SC8800-S AP Installation
- 3 Preparing the SC8800-S AP at the Depot and Shipping to the Field
- 4 Installing the SC8800-S AP in the Field
- Installation Components and Constraints
- Deploying the Access Point
- Mounting the Access Point
- Mounting the U-Joint Bracket to the Main Mounting Bracket
- Attaching the Main Mounting Bracket to a Flat Surface
- Attaching the Main Mounting Bracket to a Wooden Pole
- Attaching the Main Mounting Bracket to a Metal Pole
- Mounting the Hook Bracket to the U-Joint Bracket
- Assembling the AP Attachment Bracket and the Access Point
- Attaching the AP Attachment Bracket and AP to the Hook Bracket
- Safety-Cabling the AP
- Mounting External Antennas (Optional)
- Verifying Access Point Operation
- 5 What to Do Next
- Appendix A: Ruckus Wireless-Supplied and Customer-Ordered Parts
- Appendix B: Resetting the Access Point to Factory Default Settings
- Appendix C: Installer Mounting Dimensions
62
1/2” (12.7mm) wide stainless
steel adjustable clamps, 2.5-
inch (63.5mm) diameter
(4 pieces)
-- Factory AP
Mounting
Kit
Stainless
steel
M 25 waterproof ethernet cable
gland
(2 pieces)
902-0183-
0000
Factory AP
Small Parts
Kit
AC cable connector
(1 piece)
902-0185-
0000
Factory AP
Small Parts
Kit
Safety Cable Kit 902-0115-
0000
Factory AP
Small Parts
Kit
Ruckus Wireless 60W PoE
injector (optional)
902-0180-
XX00,
where XX is
the country
code
Optionally
customer-
ordered
Only if PoE
is used
Country-specific 3-wire AC
power cable with an IEC C13
plug on the PoE injector end
-- Customer-
supplied
Only if AC is
used
Table 21. Orderable 2.4GHz Antennas
Part Ruckus
Wireless
P/N
Notes
2.4GHz 5dBi V External Omni Outdoor
Antenna
911-0005-
VP01
Kit includes
one
vertically-
polarized
antenna
Table 20. Ruckus Wireless- and customer-supplied parts (Continued)
Part Ruckus
Wireless
P/N
Factory Kit
or
Customer
Ordered
Notes