Installation Guide
Table Of Contents
- Contents
- 1 About this Installation Guide
- 2 Planning the SC8800-S AP Installation
- 3 Preparing the SC8800-S AP at the Depot and Shipping to the Field
- 4 Installing the SC8800-S AP in the Field
- Installation Components and Constraints
- Deploying the Access Point
- Mounting the Access Point
- Mounting the U-Joint Bracket to the Main Mounting Bracket
- Attaching the Main Mounting Bracket to a Flat Surface
- Attaching the Main Mounting Bracket to a Wooden Pole
- Attaching the Main Mounting Bracket to a Metal Pole
- Mounting the Hook Bracket to the U-Joint Bracket
- Assembling the AP Attachment Bracket and the Access Point
- Attaching the AP Attachment Bracket and AP to the Hook Bracket
- Safety-Cabling the AP
- Mounting External Antennas (Optional)
- Verifying Access Point Operation
- 5 What to Do Next
- Appendix A: Ruckus Wireless-Supplied and Customer-Ordered Parts
- Appendix B: Resetting the Access Point to Factory Default Settings
- Appendix C: Installer Mounting Dimensions
65
Appendix B: Resetting the Access Point to
Factory Default Settings
You can reset the AP to its factory default settings by pressing the reset button located
inside the PoE OUT/RESET port.
1. Remove the PoE OUT/RESET blanking cap or cable gland.
2. Make sure that the AP is powered.
3. Locate the reset button inside the PoE OUT/RESET port.
4. Using a pen or a similar pointed object, press the button for 10 seconds. The PWR LED
turns red.
5. After the AP reboots, verify that the PWR LED is solid green. When the PWR LED is
solid green, it indicates that the reset process is complete.
You have completed resetting the AP to its factory default settings.
Figure 33. Location of the reset button
Reset Button