User guide
Table Of Contents
- Contents
- About This Guide
- Introducing the ZoneFlex Access Point
- Overview of the ZoneFlex Access Point
- Unpacking the ZoneFlex Access Point
- Getting to Know the Access Point Features
- Installing the Access Point
- Before You Begin
- Step 1: Preconfigure the Access Point
- Configuring for Management by ZoneDirector
- Configuring for Standalone Operation or for Management by FlexMaster
- What You Will Need
- 1. Prepare the Administrative Computer
- 2. Connect the Access Point to the Administrative Computer
- 3. Log Into the Access Point’s Web Interface
- 4. Configure the Wireless Settings
- 5. Disconnect the Access Point from the Administrative Computer
- 6. Restore the Administrative Computer’s Network Settings
- Step 2: Verify Access Point Operation
- Step 3: Deploy the Access Point
- Troubleshooting Installation
- Navigating the Web Interface
- Configuring the Access Point
- Managing the Access Point
- Viewing Current Device Settings
- Viewing Current Internet Connection Settings
- Viewing Current Local Subnet Settings
- Viewing Current Wireless Settings
- Viewing Associated Wireless Clients
- Changing the Administrative Login Settings
- Enabling Other Management Access Options
- Working with Event Logs and Syslog Servers
- Upgrading the Firmware
- Rebooting the Access Point
- Resetting the Access Point to Factory Defaults
- Running Diagnostics
- Where to Find More Information
- Numerics
- A
- B
- C
- D
- E
- F
- G
- H
- I
- K
- L
- M
- N
- O
- P
- R
- S
- T
- U
- V
- W
- Z
- Index
110
Managing the Access Point
Upgrading the Firmware
Upgrading the Firmware
You can use the Web interface to check for software updates/upgrades for the
firmware built into the AP. You can then apply these updates to the device in one of
two ways: (1) manual updating on an as-needed basis or (2) automating a regularly
scheduled update.
Before starting, decide which option you want to take:
■ Automate a regularly scheduled update
■ Run a one-time manual update right now
By default, the automatic upgrade option is disabled.
To get started with upgrading the firmware, go to Maintenance > Upgrade. When
the Maintenance > Upgrade options appear, decide which upgrade method to use.
Each of the upgrade options listed on the Upgrade page are discussed in the
succeeding sections.
Figure 57. The Maintenance > Upgrade page
Upgrading Manually via FTP or TFTP
1. In the Upgrade Method options, click FTP or TFTP.
2. Click the host name field, and then type the URL of the server. Or click the IP
address field, and then type the IP address of the server. Remember to start the
URL with ftp://.