Step-by-step Instructions

Step 2: Attaching the U-Joint bracket to the
Mounting Br
ack
et
1. Position the U-joint bracket on the mounting bracket.
NOTE: Mount the U-joint brack
et in any direction on the
mounting bracket, preferably to allow AP azimuth
adjustments. Then the AP bracket allows AP elevation
adjustments.
FIGURE 4 U-joint brack
et attached horizontally to the
mounting bracket
2. Use four 1/4-28 bolt and washer sets (A) to mount the U-joint
brack
et (B) to the mounting bracket (C). Tighten the bolts to
9.5 N.m (7 ft-lbs.)
3. Continue with Step 3A: Attaching the Mounting Bracket to a
Flat Surface on page 2 or Step 3B: Attaching the Mounting
Bracket to a Metal Pole on page 2.
Step 3A: Attaching the Mounting Bracket to a
Flat Surface
1. Place the mounting bracket at the location on the at surface
where you want to mount the AP. Use the holes on the
mounting bracket as a template to mark the locations of the
mounting holes.
FIGURE 5 Mounting bracket at surface holes
2. Remove the mounting bracket from the at surface.
3. Drill holes r
equired for the mounting hardware.
NOTE: The hardwar
e required for mounting to a wall are
not included in the mounting kit.
4. Attach the mounting bracket to the at surface using the
mounting hardwar
e.
5. Using the mounting hardware instructions, tighten the
hardware to secure the mounting bracket.
6. Continue with Step 4: Mounting the Linkage Bracket to the U-
Joint Bracket on page 2.
Step 3B: Attaching the Mounting Bracket to a
Metal Pole
1. Insert the open end of one steel clamp into the upper two
slots on Insert the open end of one steel clamp into the
upper two slots on the mounting bracket..
2. Take the other steel clamp and insert it into the lower two
slots on the mounting bracket.
NOTE: The clamps can be daisy-chained together to
accommodate larger poles.
3. Use the clamps to attach the mounting bracket to the pole.
Tighten the clamps to 3 N.m or 27 in-lbs., or per
manufacturer
’s specications.
FIGURE 6 Attaching the mounting bracket to a vertical
pole
4. Continue with Step 4: Mounting the Linkage Brack
et to the U-
Joint Bracket on page 2.
Step 4: Mounting the Linkage Bracket to the
U-Joint Brack
et
The linkage bracket attaches to the U-joint bracket using an M8
bolt and washer set. The linkage bracket is symmetrical, and
either end can be attached to the U-joint bracket.
NOTE: If you are mounting Q910 horizontally
, use the longer
(175 mm) linkage bracket. If you are mounting Q910 vertically,
use the shorter (100 mm) linkage bracket.
FIGURE 7 Vertical mounting with Short Linkage Arm
Copyright
©
2018 ARRIS Enterprises LLC. All rights r
eserved. Page 2 of 4
Published December 2018, Part Number 800-71412-001 Rev B