Step-by-step Instructions

FIGURE 4 Aaching the T-bar Bracket to the T-bar

Mounng on a Flat Surf

ace

The factory-supplied mounng screws and plasc wall anchors allow you

to aach the AP to a wall or other at surface.

1. Use the Mounng Template on the last page of this Quick Setup

Guide to mark the locaons for two drill holes on the mounng

surface.

2. Use a 4.75-mm (3/16-in.) drill bit to drill holes approximately 25 mm

(1 inch) deep into the mounng surface.

3. Insert the factory-supplied anchors (1 in Figure 5) and mounng

screws (2 in Figure 5) into the mounng surface, leaving

approximately 6 mm (1/4 inch) of the screw heads protruding for the

AP enclosure.

FIGURE 5 Flat Surf

ace Mounng

4. Place the AP onto the mounng scre

ws so the screw heads enter the

keyholes on the AP enclosure, and push the AP down unl the AP

retainer tab snaps into place.

R550 Cauon Noces

A cauon calls your aenon to a possible hazard that can damage

equipment.

CAUTION! The equipment c

an be connected to PoE networks without

roung to the outside plant.

For More Informaon

or informaon on how to congure and manage the AP, refer to the

Ruckus Wireless Indoor Access Point User Guide, available from hps://

support.ruckuswireless.com.

ARRIS, the ARRIS logo, CommScope, Ruckus, Ruckus Wireless, the Ruckus logo,

and the Big Dog design are trademarks of CommScope, Inc. and/or its aliates.

Wi-Fi Alliance, Wi-Fi, the Wi-Fi logo, Wi-Fi Cered, the Wi-Fi CERTIFIED logo,

Wi-Fi Protected Access, the Wi-Fi Protected Setup logo, Wi-Fi Protected Setup,

Wi-Fi Mulmedia and WPA2 and WMM are trademarks or registered

trademarks of Wi-Fi Alliance. All other trademarks are the property of their

respecve owners.

2020 CommScope, Inc. All righ

ts reserved. Page 3 of 4

Published March 2020, Part Number 800-72433-001 Rev A

Ruckus Wireless Inc.

350 W. Java Dr., Sunnyvale CA 94089 USA