User Manual
FLEXCLEAN® ALL-IN-ONE FLOOR CLEANER | User Manual rugdoctor.com | 1-800-784-3628
8 9
5
1 3
6
Assembly FLOW CONTROL DIAL
• Main Handle
• FlexClean® All-In-One Floor Cleaner
• Soft Surface Nozzle (carpet/rug)
• Hard Surface Nozzle (hard floor)
Your Rug Doctor® FlexClean® All-In-One Floor Cleaner comes in 4 easy-to-assemble components:
*A #2 Phillips screwdriver is required for Steps 1 and 4.
Attach the Nozzle Secure The Cord
The FlexClean® All-In-One Floor Cleaner is equipped with a Flow Control System
designed to address all of your cleaning needs with one machine.
The three different FLOW CONTROL DIAL settings and usage information are
listed as follows:
WARNING!
DO NOT plug in your FlexClean® All-In-One Floor Cleaner until you are
familiar with all instructions and operating procedures.
QUICK DRY
USE ONLY FOR SOFT SURFACE CLEANING (carpet/area rugs).
Quick Dry mode provides a lighter clean by applying less water and cleaning solution and
reduces the drying time after cleaning (when compared to DEEP CLEAN mode).
Great for use on carpet, area rugs, upholstery, and spot cleaning.
CARPET DEEP CLEAN
USE ONLY FOR SOFT SURFACE CLEANING (carpet/area rugs).
Deep Clean mode delivers a traditional deep clean to your soft surfaces and is recommended
to achieve the best deep cleaning results.
IMPORTANT!
The Deep Clean Mode dispenses three times the solution of the Hard Floor Clean Mode.
HARD FLOOR
USE ONLY FOR SEALED HARD FLOOR CLEANING.
Delivers the perfect amount of solution and water on sealed hard floors such as stone, tile,
laminate, vinyl, and sealed hardwood.
ATTENTION! DO NOT use DEEP CLEAN mode on hard floors as it will over-wet hard floors
4
Carpet Nozzle Hard Floor Nozzle
Remove Screw Line up the Hole
Use #2 Phillips
screwdriver to remove
screw in Handle
Connector.
Align the hole in the Main
Handle with the hole on the
Handle Base. Insert the Screw
and use a
#2 Phillips
screwdriver
to tighten
the Screw
by turning
clockwise.
Insert
the
Handle.
2
Insert the
Main Handle
into the
Handle
Connector.
Choose One
Attach Carpet Nozzle or
Hard Floor Nozzle as per
desired area to clean.
1. Align the nozzle tabs with
the slots in the base
(in front of the brushroll).
2. Rotate toward machine.
3. Latch the nozzle by pressing
down on the top of the nozzle
until you hear a “click.”
Wrap the cord around
the Power Cord Wrap.
Now you are ready to
clean.
1
2
3