Manual

22
5. To remove the stock: (Be certain the bolt and magazine have been removed
from the rifle.)
NOTE: On the K77/22RP & RSP models, disregard step “b” and magazine well
liner in step “c”, below.
a. Remove the rear mounting screw in the trigger guard.
b. Swing the rear of the trigger guard out of the stock to clear trigger.
Unhook trigger guard assembly from the receiver. Remove the trigger guard
assembly.
c. Remove the front mounting screw and magazine well liner.
d. VERY CAREFULLY lift the barrel/receiver assembly from the stock.
6. To remove the barrel: (.22 LR, .22 Magnum, and .17 HMR Rifles Only
)
a. Remove the (2) barrel retainer screws and barrel retainer.
b. Slide the barrel forward to remove it from the receiver.
NOTE: .22 Hornet and .44 Magnum caliber barrels are threaded into the
receiver and should not
be removed except by the factory.
7. To remove the trigger: (Safety Selector should be in the “Fire” position).
a. While holding the trigger in place, press out the trigger pivot pin.
(Caution: Trigger is spring loaded and under tension --- be careful!).
b. Remove the trigger and trigger/sear spring.
8. To remove the sear:
a. Press out the sear pivot pin.
b. Turn receiver upside down and slide sear forward. Sear will drop out of
the top slot in the receiver.
9. To remove safety assembly:
a. Rotate the safety selector so that the upper section is positioned fully
over the center of the receiver tang.
b. While holding the safety selector in place with thumb and forefinger,
slide the retainer up out of receiver. (Caution: Safety Selector is under
spring tension from a spring and plunger acting against the lower section of
the safety selector. The spring and plunger will jump out if not contained).
c. Lift out the safety selector.
d. Remove the safety selector detent and safety selector detent spring.
10. To remove the bolt stop:
a. Depress the bolt stop plunger (with the tip of a jewelers screwdriver
blade or similar tool) and remove the bolt stop from the pivot. (Caution:
This spring and plunger will jump out.)
b. Remove the bolt stop plunger and bolt stop plunger spring.
CAUTION: The bolt sleeve assembly is intended to be a permanent
assembly and should not be disassembled. The parts are under great
spring pressure and if disassembled could fly apart with sufficient force to
cause serious injury. Also, special tools are required to correctly reassem-
ble this part.
!