Manual

REASSEMBLY

(Again, Be Sure Rifle Is Unloaded)

1. To replace the bolt stop:

a. Replace the bolt stop plunger and bolt stop plunger spring. (Be certain

that the step flats on the plunger match the flats on the mating surface of

the bolt stop.)

b. Depress the bolt stop plunger and replace the bolt stop on the pivot.

2. To replace the safety assembly:

a. Place the safety selector detent and safety selector detent spring into the

hole in the receiver.

b. Set the safety selector in place with its upper section positioned over the

center of the receiver tang.

c. While holding the safety selector in place with thumb and forefinger,

slide the safety selector retainer into dovetail from the top. Align the notch

in the safety selector retainer with the sear pivot pin hole.

3. To replace the sear:

a. Place the rear end (the end with the hole in it) of the sear into the slot

from the top of the receiver. Swing the rear end of the sear up and slide the

sear into position until the hole in the sear is aligned with the mating holes

in the receiver.

b. Insert the sear pivot pin.

4. To replace the trigger:

a. Place the trigger/sear spring over the dimple in the trigger.

b. Assemble the trigger while aligning the spring with the dimple on the

sear.

c. While holding the trigger in position, replace the trigger pivot pin.

5. To replace the barrel: (.22 LR, .22 Magnum, and .17 HMR Rifles Only

)

a. Assemble the barrel into the receiver assembly.

b. Replace the barrel retainer and barrel retainer screws.

6. To replace the barrel/receiver assembly into the stock: (Caution: Be certain

that the pivot pins are not protruding from either side of the receiver.)

NOTE: On the K77/22RP & RSP models, disregard magazine well liner instal-

lation in step “b”, and all of steps “c” & “d”, below.

a. Carefully install the barrel/receiver assembly into the stock, making sure

the barrel/receiver assembly is in the most rearward position.

b. Install the magazine well liner and front mounting screw.

c. Hook the forward end of the trigger guard assembly into the receiver.

d. Swing the rear of the trigger guard into position.

e. Install the rear mounting screw.

7. To assemble the bolt:

a. Place the firing pin into the mating slot in bolt sleeve assembly.

b. Slide the bolt sleeve assembly into the bolt from the rear.

c. Screw the bolt sleeve into the bolt to position shown.

d. Install the breech block into the front end of the bolt.

e. Align the holes in the breech block with the hole in the bolt.