Manual

Add itionally, the pistol has a separate internal firing pin block which will not allow
the firing pin to move forward and contact the cartridge until the operator pulls the
trigger with the safety off (in its “fire” position).
The pistol can and should be loaded and unloaded with the safety engaged in its
“safe” position (lever fully down, white dot and the letter “S” exposed). The safety
should be in its “safe” position at all times except when the user is deliberately posi-
tioned to fire at a selected target. See Figures 1 and 2, below, which illustrate the two
positions of the safety.
FIGURE 1 FIGURE 2
11
"FIRE" POSITION
"SAFE" POSITION
Red dot
exposed
White dot and
letter "S" exposed
WARNING - MANUAL SAFETY
Placing the safety in an intermediate position
between “safe” and “fire” can result in the user
thinking the pistol is in a safe or fire position
when it is not. Pulling the trigger with the
safety in an intermediate position may cause
the pistol to fire. Therefore, always move the
safety fully
to its intended position and then
check to be sure it is where you want it to be.
Unless the white dot and the letter “S” are
both
fully visible, the safety is not on. Unless
the red dot is fully visible, the pistol is not
absolutely ready to fire.
NEVER PUT SAFETY 1/2 ON