Manual

and forward (see Figure 4, below) until it locks in its lower position. This will
permit forward movement of slide. Further disassembly is impossible unless
this is done.
22
ALIGN
INDEX MARKS
3
DEPRESS
EJECTOR
1
SAFETY
“ON”
REMOVE
MAGAZINE
2
FIGURE 4
Press slide stop up. Depress ejector.
FIGURE 5A
Slide stop in disassembly position.
FIGURE 5B
4. Remove fingers from ejection port. Grasp slide tightly. Now press down on
slide stop and allow slide to move slowly
forward until the slide stop spring
retainer pin is aligned with the front edge of the slide stop notch. Press in on
right-hand end of slide stop and pull slide stop out of frame to the left until it
locks in its withdrawn position. (See Figure 5A, above.) Do not attempt to
pull it completely out of the frame. For the P94 & P944 pistols, press down
on the slide stop and allow the slide to move slowly forward until the ver
tical
index marks on the left side of the frame are aligned. (See Figure 5B, above.)
5. Push slide forward and remove entire slide assembly to the front.
6. With slide held upside down, lift rear end of guide rod to disengage it from its
seat against the barrel lug. Withdraw spring and guide rod to the rear of the
slide. CAUTION: Spring is under tension!
7. Pull barrel upward out of slide slightly and withdraw to the rear.
4
5
PULL OUT
SLIDE STOP
DISASSEMBLY
NOTCH
ALIGN NOTCH
WITH PIN