Manual

TO REASSEMBLE
1. Be certain chamber and magazine are empty.
2. With slide held upside down, replace barrel and push it rearward into its
locked position.
3. Replace guide rod and recoil spring assembly (the smaller diameter end of
spring against collar) into position. Rear end of guide rod seats against barrel
lug. Barrel link must be in vertical (hole showing) position, or pistol cannot
be reassembled.
4. Be certain that ejector is locked in its lower (forward) position and that ham-
mer is in its fired (uncocked) position.
5. Replace slide onto frame.
6. Pull slide back until disassembly notch is opposite lug on slide stop. Press
slide stop all the way through the frame to the right.
7. Allow slide to move fully forward.
8. Replace empty magazine in frame through butt of pistol. This action returns
the ejector to its working position. This pistol will not function normally
unless the ejector is in its upward (rearward) position.
MAGAZINE INSPECTION AND CARE
Check the magazine frequently. The magazine follower must move freely and
have adequate tension so that each cartridge is quickly raised to the feeding posi-
tion. The magazine lips should be clean and free of cracks, dents, or nicks, so
that cartridges are held in their proper feeding position.
If the magazine becomes dirty, it should be disassembled and thoroughly
cleaned. You could encounter two types of Ruger magazines, with either a
pinned base or a snap-on base. The following disassembly instructions apply:
23
Always unload a firearm
before cleaning, lubrication,
disassembly or assembly.
UNLOAD BEFORE DISASSEMBLY
WARNING - DISASSEMBLY
3
2
1
4
SAFETY “ON”
8. This completes normal fieldstripping for routine cleaning and lubrication
purposes. Further disassembly of slide or frame components is not recom-
mended and should only be undertaken by the factory.