Manual

3. Using powder solvent on a clean patch or bristle brush, remove powder
residue from all components of the mechanism. After cleaning, run a dry
patch through the bore, then follow with a patch that is very lightly oiled.
Wipe all surfaces clean with cloth, then wipe all surfaces with a patch or cloth
that has been very lightly oiled.
4. NOTE: Only a light application of oil is needed to provide adequate lubrica-
tion of moving parts and to prevent rust. Excess accumulations of oil tend to
attract particles of dust and dirt and may congeal in cold weather, which can
interfere with the safe and reliable function of the pistol.
5. Before firing, remove all oil and grease from the bore.
25
WARNING - LUBRICATION
IMPROPER LUBRICATION
DESTROYS GUNS
Firing a pistol with oil, grease, or any other material
even partially obstructing the bore may result in damage
to the pistol and serious injury to the shooter and those
nearby. Do not spray or apply lubricants directly on
ammunition. If the powder of a cartridge is affected by
the lubricant, it may not be ignited, but the primer fir-
ing may push the bullet into the bore where it may be
lodged. Firing a subsequent bullet into the obstructed
bore may damage the pistol and cause serious injury or
death to the shooter and those nearby. Use lubricants
properly. You are responsible for the proper care and
maintenance of your firearms.
STORAGE
GUNS SHOULD NOT BE STORED LOADED!
Sturm, Ruger also offers gun safes for sale as a means to secure more than one
firearm. Please call [phone] for details and ordering information.
Do not keep the pistol stored in a leather holster or case. Leather attracts mois-
ture, even though the holster or case may appear to be perfectly dry.
TO RENDER THE PISTOL INOPERATIVE FOR SAFE STORAGE
With the muzzle pointed in a safe direction, remove the magazine, retract the
slide, and check the chamber to be sure the pistol is completely unloaded! Keep
the muzzle pointed in a safe direction, and press upward on the slide stop. Insert
a finger into the action and press the ejector assembly fully forward. Next, pull
the slide stop pin out the left side of the pistol frame until it stops. Now remove
the slide and barrel assembly forward off the front of the frame.
USE THE LOCKING DEVICE SUPPLIED WITH THE PISTOL FOR STORAGE.
(S
EE PAGE 5)