RC-FC500 RC-FC500B Fabric Rain Cover for Canon and select Nikon DSLRs • Fits lenses from 7″–14″ long and lens diameters of 4″–4.
Thank you for choosing Ruggard. Designed for use with longer lenses, this durable and water-resistant rain cover protects your Canon DSLR camera or Nikon DSLR camera with a square viewfinder from conditions like rain, dust, and mud, so you can shoot in almost any weather condition. The rain cover’s control window provides full visibility of your camera’s monitor and top and rear controls.
Precautions • Please read and follow these instructions and keep this manual in a safe place. • Do not attempt to take apart or repair this product. • Make sure that this product is intact and that there are no missing parts. • Water may enter the rain cover through the seam in the window and the neck strap slits. If the camera or lens comes into contact with water, wipe it dry immediately. • When the rain cover is wet, do not leave it attached to the camera and lens.
Overview Lens barrel sleeve Contents Include: • Rain cover • Three (3) eyepiece assemblies: One (1) small One (1) medium One (1) large • Drawstring bag • User manual Control window Eyepiece port Neck strap slits Touch fasteners Eyepiece Eyepiece Cap Front Ridges Back Tab Release 4 Tabs
Before You Start Before you install one of the included eyepiece assemblies, you will need to determine which one fits your camera. The rain cover comes with three sizes of eyepiece assembly (small, medium, and large). 1. Remove your camera’s eyepiece by pinching the eyepiece and pulling it up and off your camera’s viewfinder. 2. Mount one of the included eyepiece assemblies by sliding the eyepiece onto your camera’s viewfinder until it locks into place.
Installing the Eyepiece 1. Separate the eyepiece assembly by pulling the tab release on the eyepiece and rotating the eyepiece cap. 2. Lay the rain cover flat, with the lens barrel sleeve facing away from you and all the touch-fasteners unfastened. Place the eyepiece cap in the port with the ridge lines in the cap at the 9 and 3 o’clock positions.
Installing the Eyepiece 3. Flip the rain cover over, making sure the lens barrel sleeve is facing away from you, and check the inside of the cover to make sure the larger of the two tabs on the eyepiece cap is at the 6 o’clock position. If necessary, rotate the eyepiece cap 180°. 4. Place the eyepiece on the eyepiece cap so the tab release on the eyepiece is at the 9 o’clock position.
Installing Your Camera 1. With the lens mounted on your camera, insert your camera’s lens barrel into the lens barrel sleeve. Tip: For best results, use this rain cover in combination with a lens hood (sold separately). Attach the hood to your lens before inserting it into the lens barrel sleeve. 2. Mount the eyepiece assembly on your camera by sliding the eyepiece onto your camera’s viewfinder until it locks into place.
Installing Your Camera 3. Match up the end of the lens barrel with the end of the lens barrel sleeve, and adjust the touch fastener around the lens for a snug fit. 4. Fasten the touch fasteners on the sides and bottom of the rain cover. If you are using a neck strap, make sure it protrudes from the slits at the tops of the side touch-fasteners.
Installing Your Camera If you plan on shooting handheld photography, insert your hand through the bottom opening of the rain cover to hold your camera. If you are going to use a tripod, mount your camera on the tripod through the bottom opening of the rain cover.
One-Year Limited Warranty This RUGGARD product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later.
© Copyright 2014 Gradus Group www.ruggard.
