User Manual

Jeep® Mirror Replacement Kit ( Wrangler TJ - JK)
Page 1
Rev (4) 6/02/2011
HARDWARE NOTE: (2) New 5/16” bolts have been supplied for TJ-LJ
applications. JKs will reuse factory hardware.
Item List:
(1) 6” Round Mirror (1) M8 Bolt (1) Foam Pad
(1) M8 Flat Washer (1) M8 Lock Washer (2) 5/16” bolt
(1) Mounting Bracket (1) Knob
(1) Billet Bushing (1) Mirror Arm
NOTE: This mirror kit ts both passenger and driver side. The mirror arm has two sets of holes for
mounting on either side of vehicle. Disassemble mirror arm from mounting bracket before
you begin so arm can be properly positioned for installation by using the correct hole locations .
Step 1. Using T40 torx wrench remove
two upper windshield bracket
bolts (JK). For TJ remove two
ush mount torx head bolts just
in front of door hinge (Pic 1-2)
TJ’s will use new 5/16” bolts.
Step 2. Install mounting bracket with
welded nut facing down.
(pic.3). Tighten bolts.
pic.1
P/N: 11026.11 - Stainless Steel 11026.10 (PAIR)
Step 3. Attach mirror head to at side
of arm using M8 bolt, at
washer and lock washer.(pic.4)
11025.11 - Black 11025.10 (PAIR)
pic.2 pic.3
pic.4
pic.5
Step 4. Slide bushing on to arm. Arms
have 4 alignment holes for
universal installation (left/right).
Rotate arm to match passenger or
drivers side application (pic.5).
Step 5. Install arm into mounting
bracket. Open doors to check
clearance to mirror.
Tighten knob (pic.6)
NOTE: Arms have two sets of mounting holes. The arms are drilled to t either side of the vehicle.
pic.6
Step 6. Adjust mirror head into desired
position. Tighten screws. DO
NOT over tighten. Mirror head
should be tight but able to be
adjusted if needed (pic.7).
Step 7. When doors are reinstalled
remove mirror arm from bracket.
Place bushings back into arm.
Tighten knob. (pic.8-9)
pic.7
NOTE: TJ applications are designed
to be used with doors o. Some
visibility on passenger side will
be blocked if used with doors.
pic.8 pic.9
JK Install TJ-LJ Install
Copyright Omix-Ada 2011