User Manual

2. Place light bar over the tube sleeves of both the Left and Right Side Brackets. Adjust the brackets

as necessary to accommodate the tube.

Page 1 of 2

11232.20,11138.20

1. Locate frame mounting holes behind the bumper on the left side of the vehicle. Slide one M12 ange nut

behind the lower frame hole to attach the Left Side Bracket as shown. Use this nut to secure the bottom of the

Left Side Bracket in position with a M12 Hex Bolt and M12 Flat Washer. Place a M12 Flange Nut on the supplied

Allen Key. Lower the nut behind the upper frame mount hole. Insert a M12 Hex Bolt and M12 Flat Washer to

secure the top of the bracket. Do not fully tighten the bolts at this time. Repeat for Right Side Bracket.

Contents:

1. Light Bar (1)

2. Left Side Bracket (1)

3. Right Side Bracket (1)

4. M12 Hex Bolt (4)

5. M12 Flat Washer (4)

6. M12 Flange Nut (4)

8. M8 button Head Bolts (4)

9. M8 Flat Washer (8)

10. M8 Lock Nut (4)

11. Hex Key (not shown) (1)

07-10 JK Wrangler Light Bar

PAGE 1
1232.20,11138.20 07-10 JK Wrangler Light Bar Contents: 1. 2. 3. 4. 5. 6. 8. 9. 10. 11. Light Bar (1) Left Side Bracket (1) Right Side Bracket (1) M12 Hex Bolt (4) M12 Flat Washer (4) M12 Flange Nut (4) M8 button Head Bolts (4) M8 Flat Washer (8) M8 Lock Nut (4) Hex Key (not shown) (1) 1. Locate frame mounting holes behind the bumper on the left side of the vehicle. Slide one M12 flange nut behind the lower frame hole to attach the Left Side Bracket as shown.
PAGE 2
3. Use the M8 Button Head Bolts, M8 Flat Washers, and M8 Nylock Nuts to secure the Light Bar to the Mounting Brackets. Install and tighten the lower bolts first, then install the upper ones. Tighten to 20 ft-lbs. 4. Tighten all hardware. Install lighting per manufacturer's instructions. Rugged Ridge Limited Warranty Applies to Rugged Ridge Products by Omix-ADA Inc. Please find warranty card supplied with product for more information. Warranty card should be filled out and returned to address listed below.