User Manual

, Inc.

Page 1/2

2. Hold and position deector to determine mounting position.

1. Clean the painted surface where the deector will be

attached using Isopropyl Alcohol (Rubbing Alcohol).

Note: Application and product my vary from illustrations. Caution: Before driving, ensure that all deectors

are secured properly.

Please read all instructions before installation of Wind/Rain Deectors

Preparations Before Installation

∙ Check and determine if Wind/Rain Deectors are the correct t for your vehicle.

∙ Wash and Clean all mounting surfaces of the vehicle using Isopropyl Alcohol (Rubbing Alcohol).

∙ To ensure proper bond apply only when temperatures of mounting surfaces is between 65-110°F.

∙ Be sure all mounting surfaces are dry before installation

3. Remove 2” of tape liner from each end of the deector.

Side Window Air/Rain Deflectors

PAGE 1
Page 1/2 Side Window Air/Rain Deflectors Note: Application and product my vary from illustrations. Caution: Before driving, ensure that all deflectors are secured properly. Please read all instructions before installation of Wind/Rain Deflectors Preparations Before Installation ∙ Check and determine if Wind/Rain Deflectors are the correct fit for your vehicle. ∙ Wash and Clean all mounting surfaces of the vehicle using Isopropyl Alcohol (Rubbing Alcohol).
PAGE 2
Page 2/2 Side Window Air/Rain Deflectors 4. Place the deflector in a desired location on the door. 5. Once the deflector is positioned, carefully pull and remove the tape liner. Apply firm pressure along mounting surfaces to secure. 6. Apply same methods to the rear deflectors (if applicable). 460 Horizon Drive #400 | Suwanee, GA 30024 USA | www.omix-ada.com | Copyright © 2013 Omix-Ada ®, Inc.