User Manual

Step 1. Raise the hood and hold open with the factory prop rod. Position the bug
deector against the hood as it would be mounted. Place some small pieces of
tape on the hood by the corners of the bug deector to mark the mounting
location.
Note: If the retaining screws are going to be used you will need to mark the holes that will be drilled at this time. Use the pre drilled holes
in the bug deector to mark the area to be drilled.
Step 2. Clean the mounting area on the hood with rubbing alcohol.
Step 3. Mount the bug deector using one of the following methods.
REV. 11/10
Page 1 of 1
SB
For Technical Assistance Contact:
OMIX-ADA Tech Support
Email: [e-mail]
Web: www.Omix-Ada.com
Phone: [phone]
PLEASE REVIEW ALL INSTRUCTIONS BEFORE YOU BEGIN.
JK BUG DEFLECTOR
11350.02
Method B: Adhesive tape and Screw- Drill a pilot hole using a 5/64” drill bit for the
four mounting holes. Use caution when drilling holes. Holes only need to go
thru the rst layer of metal. Extreme pressure while drilling may cause
damage to the outer hoodsurface. Attach the bug deector to the hood with
the screws and washers provided. Do not overtighten.
Method A: Adhesive tape- Peel back approximately 2” of tape liner on each side of the
tape strips. Place bug deector on the hood at the marked location. Once the
bug deector is in position remove the remaining protective tape liner o
each strip of tape. Apply frim pressure to the bug deector against the hood
to ensure a good bond. Do Not install if outside temperature is below 65F. or
over 100F. Allow part to sit overnight before driving.