Owners manual

769515
Page
1
3.27
.07
IMPORTANT NOTICE:
Carefully read instructions before attempting to install this product. Rugged Ridge– Outland are in no way responsible for
any damage to the vehicle or persona injury that may occur during the installation or use of this product.
INCLUDED COMPONENTS
2 – Arm Rest Padding
2 – Brackets (Left & Right)
4 – Rubber Plugs
4 – Sheet Metal Screws
4 – Phillips Machine Screws
INSTALLATION INSTRUCTIONS
1) Remove the factory door closure strap by unscrewing the two screws holding them in place (Figure 1).
2) After removing factory door strap from door panel, there will be two cavities on each door. Use Rubber
Plugs to cover cavities (Figure 2).
3) Attach Bracket to door using the same holes that previously held the factory door closure strap. Use the
included Sheet Metal Screws to attach Bracket to door (Figure 3)
4) Mount Arm Rest Padding onto Bracket. Use the included Phillips Machine Screws to attach Padding
onto Bracket (Figure 4).
5) Adjust Padding fore and aft to your position of maximum comfort.
Installation Instructions
Arm Rest
TJ Wrangler
Part#: 769515
Rugged Ridge #: 11830.02
Figure 1 Figure 2
Figure 3 Figure 4
Rubber Plugs
Factory Screws
Sheet Metal Screws
Phillips
Machine
Screws