User Manual
15104.53
ADJUSTABLE TIRE DEFLATOR KIT, RUGGED RIDGE, UNIVERSAL APPLICATION
Please read and follow Setting instructions carefully.
Step 1. Deate a (spare) tire to your preferred deation pressure.
Step 2. With lock ring adjusting cap wound down, screw your tire deator on the valve
stem making sure its clean and threads are in good condition.
Step 3. Loosen cap (counterclockwise) until deator pops open, then immediately
tighten cap to the position where air stops exhausting.
Step 4. Turn lock ring up to adjust cap and tighten.
Your Tire Deator is now set to your preferred deation pressure. Adjustments to you
deators can be made at the rate of 3 psi per half turn of the adjusting cap. When the tire
pressure and the deator setting is within 8 psi, a manual start may be required by installing
the deator then lifting the center pin to start operation. Keep deators clean and dry.
Do not interchange components. Remove after deation.
Page 1 of 1
SB
REV. 1/11
For Technical Assistance Contact:
OMIX-ADA Tech Support
Phone: 1-800-449-6649
Email: techsupport@omix-ada.com
Web: www.Omix-Ada.com