Manual

11560.11

Jeep® JK Wrangler Tube Front Bumper with Winch Plate

Contents:

1. Tube Bumper (1)

2. Winch Plate (1)

3. Nut Plate (2)

4. M10 Washer (2)

5. M10 Bolt (2)

6. M12 Lock Nut (8)

7. M12 Washer (8)

8. M3 Lock Nut (8)

1. Disconnect fog lights. Remove 4 nuts per frame horn that hold the original front bumper to the vehicle.

Remove original bumper.

2. Install the original fog lights into the Center Section from the back (Figure 2a). Use the (8) M3 lock

nuts to secure them (Figure 2b).

Page 1 of 3

Figure 2bFigure 2a

PAGE 1
1560.11 Jeep® JK Wrangler Tube Front Bumper with Winch Plate Contents: 1. Tube Bumper (1) 2. Winch Plate (1) 3. Nut Plate (2) 4. M10 Washer (2) 5. M10 Bolt (2) 6. M12 Lock Nut (8) 7. M12 Washer (8) 8. M3 Lock Nut (8) 1 7 6 2 5 4 3 8 1. Disconnect fog lights. Remove 4 nuts per frame horn that hold the original front bumper to the vehicle. Remove original bumper. 2. Install the original fog lights into the Center Section from the back (Figure 2a). Use the (8) M3 lock nuts to secure them (Figure 2b).
PAGE 2
3. Remove the grille from the Jeep®. This is done by removing the 6 plastic fasteners from across the top of the grille, removing the blinker bulbs from their housings by untwisting them, and then pulling the grill away from the vehicle from the bottom, which will release the push fasteners. 4.
PAGE 3
. Tighten all hardware. Reconnect Fog Lights. Installation of the Bumper is now complete! Note: This bumper is not intended to be used for off road vehicle recovery. Congratulations on the purchase and installation of a quality Rugged Ridge product! LIMITED 90 DAY WARRANTY Applies to Rugged Ridge by Omix-Ada Inc.