Manual

ManualsBrandsRugged Ridge ManualsCarXHD Soft Top, Black Diamond, 07-09 Jeep Wrangler Unlimited (JK)

4DR JK SOFT TOP INSTALLATION INSTRUCTIONS

Step 1. Remove the quarter windows and rear window. Remove the tailgate bar

from the rear window. The tailgate bar will be reused with the new top.

Release the plastic window strips that retain the top above the front doors.

Release the windshield latches on the front header. Do not fold the top back

at this time.

PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN.

Step 2. Release the rear corners of the top. Pull down and out on the rear corners

to remove the fabric from the belt rail. Repeat this procedures for both sides.

Step 3. Remove both sets of (4) Phillips head screws on each rear bow using a (#2)

Phillips head screwdriver. Do not use power tools. Set the screws aside as

they will be used to attach the new top.

Step 4. Unfasten the hook and loop retainer that secures the top to the bow located

above the center roll bar. It may be necessary to lower the top at this time to

aid in the removal.

13741.35

Rev. 4/11

Page 1 of 3

Kit Contents:

1. Soft top fabric skin

2. Rear quarter windows (2)

3. Rear window

Tools required:

1. Phillips head screwdriver

2. Safety goggles

3. Tape

Note: For ease of installation temperature must be above 72 deg Fahrenheit. Safety

goggles should be worn when handling old deteriorated fabric.

Summary of content (3 pages)

PAGE 1
3741.35 4DR JK SOFT TOP INSTALLATION INSTRUCTIONS Kit Contents: 1. Soft top fabric skin 2. Rear quarter windows (2) 3. Rear window Tools required: 1. Phillips head screwdriver 2. Safety goggles 3. Tape PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN. Note: For ease of installation temperature must be above 72 deg Fahrenheit. Safety goggles should be worn when handling old deteriorated fabric. Step 1. Remove the quarter windows and rear window. Remove the tailgate bar from the rear window.
PAGE 2
13741.35 4DR JK SOFT TOP INSTALLATION INSTRUCTIONS Step 5. Lower the soft top and bow assembly. With the top collapsed on the rear of the vehicle, remove the screws that fasten the soft top fabric to the bottom corners of the header. Set the screws aside as they will be used to attach the new top. Step 6. With the assistance of a second person, raise the top and bow assembly in the up position. Lock the header to the windshield. Carefully drape the top over the windshield onto the hood.
PAGE 3
13741.35 4DR JK SOFT TOP INSTALLATION INSTRUCTIONS Step 10. Re-attach the hook and loop retainer around the front bow that is above the center roll bar. Step 11. Insert the rear corners of the soft top into the belt rail on the rear of the vehicle. Step 12. Install the side windows and rear window onto the top. Replace the tailgate bar into the rear window. Step 13. Secure the top above the doors by inserting the plastic retainer strips into the door surround. Your new top installation is now complete.