User's Manual
Table Of Contents
- About this User Guide
- Table Of Contents
- Chapter 1– Setting Up And Administering The Switch
- Chapter 2 - Configuring MAC Address Management
- Chapter 3 – Configuring the Ports
- Chapter 4 – Configuring VLANs
- Chapter 5 – Configuring Class of Service
- Chapter 6 – Configuring Rapid Spanning Tree
- Chapter 7 – Configuring Multicast Filtering
- Chapter 8 – Diagnostics
- Chapter 9 – Using Ethernet And RMON Statistics
- Introduction
- View Ethernet Statistics
- View Ethernet Port Statistics
- Remote Monitoring (RMON)
- RMON Historical Statistics Concepts And Issues
- RMON Alarms And Events Concepts And Issues
- The Alarm Process
- Alarm Generation And Hysteresis
- Delta vs. Absolute Values
- Configure RMON Alarms
- Configure RMON Events
- RMON Event Logs
- Troubleshooting
- Chapter 10 - Using The CLI Shell
- Chapter 11 – Upgrading Firmware And Managing Configurations
- Appendix A - Menu Tree
- Appendix B - SNMP MIB Support
- Appendix C – SNMP Trap Summary
- Appendix D – RMON Acceptable MIB Parameters
- Index
Appendices
GenericTrap (String “MAC address is learned on secure port”)
GenericTrap (Intermittent link)
APPENDIX D – RMON ACCEPTABLE MIB PARAMETERS
The following tables present the MIB parameters that may be used to generate
RMON alarms.
IF-MIB (RFC 2863)
ifInOctets The total number of bytes received on the interface, including
framing characters.
ifInUcastPkts The total number of bytes of all the data bytes received on the
line, including bytes from bad packets and framing octets.
ifInDiscards The number of received packets that are dropped due to lack
of receive buffers.
ifInErrors The number of received packets that contained errors
preventing them from being deliverable to a higher-layer
protocol.
ifOutOctets The total number of bytes transmitted out of the interface.
ifOutUcastPkts The total number of transmitted packets that were not
addressed to a multicast or broadcast address.
ifInMulticastPkts The total number of good packets received that were directed
to a multicast address.
ifInBroadcastPkts The total number of good packets received that were directed
to the broadcast address.
ifOutMulticastPkts The total number of packets transmitted that were directed to
a multicast address.
ifOutBroadcastPkts The total number of packets transmitted that were directed to
the broadcast address.
ifHCInOctets The total number of bytes received on the interface, including
framing characters.
ifHCInUcastPkts The total number of bytes of all the data bytes received on the
line, including bytes from bad packets and framing octets.
ifHCInMulticastPkts The total number of good packets received that were directed
to a multicast address.
ifHCInBroadcastPkts The total number of good packets received that were directed
to the broadcast address.
ifHCOutOctets The total number of bytes transmitted out of the interface.
ifHCOutUcastPkts The total number of transmitted packets which were not
addressed to a multicast or broadcast address.
ifHCOutMulticastPkts The total number of packets transmitted that were directed to
a multicast address.
ifHCOutBroadcastPkts The total number of packets transmitted that were directed to
the broadcast address.
RuggedCom
109