User's Manual
Table Of Contents
- About this User Guide
- Table Of Contents
- Chapter 1– Setting Up And Administering The Switch
- Chapter 2 - Configuring MAC Address Management
- Chapter 3 – Configuring the Ports
- Chapter 4 – Configuring VLANs
- Chapter 5 – Configuring Class of Service
- Chapter 6 – Configuring Rapid Spanning Tree
- Chapter 7 – Configuring Multicast Filtering
- Chapter 8 – Diagnostics
- Chapter 9 – Using Ethernet And RMON Statistics
- Introduction
- View Ethernet Statistics
- View Ethernet Port Statistics
- Remote Monitoring (RMON)
- RMON Historical Statistics Concepts And Issues
- RMON Alarms And Events Concepts And Issues
- The Alarm Process
- Alarm Generation And Hysteresis
- Delta vs. Absolute Values
- Configure RMON Alarms
- Configure RMON Events
- RMON Event Logs
- Troubleshooting
- Chapter 10 - Using The CLI Shell
- Chapter 11 – Upgrading Firmware And Managing Configurations
- Appendix A - Menu Tree
- Appendix B - SNMP MIB Support
- Appendix C – SNMP Trap Summary
- Appendix D – RMON Acceptable MIB Parameters
- Index
RuggedSwitch™ User Guide
Administration Menu
The Administration command provides the menu shown in the following Figure.
Figure 2: Administration Menu
Configure IP Services
The Configure IP Services command provides the ability to change the IP
Address/mask, Gateway address, Inactivity Timeout, Telnet Sessions Allowed,
TFTP Server and SNMP Get Community parameters.
Note:
These parameters are not changed during a factory reload. The following figure shows
the settings as shipped from the factory.
Figure 3: IP Services Configuration Menu
My Switch Administration Admin Access
Configure IP Services
Configure System Identification
Configure Passwords
Configure Time and Date
Configure SNMP Management Stations
CTRL Z
Hl S
Sh ll
My Switch IP Services Configuration Admin Access
IP Address Type Static
IP Address 192.168.0.1
Subnet 255.255.255.0
Gateway
Inactivity Timeout 5 min
Telnet Sessions Allowed 8
TFTP Server Get Only
SNMP Get Community public
<CTRL> Z-Help S-Shell
IP Address Type
This parameter specifies if the IP configuration is static (i.e. configured through
this menu), or dynamically assigned. If dynamic IP configuration is chosen, the IP
Address, Subnet and Gateway fields will become unavailable for editing and will
not be displayed. These values will be loaded via Dynamic Host Configuration
Protocol (DHCP) and may be viewed using the “ipconfig” shell command.
IP Address
This parameter specifies the IP address of the switch.
RuggedCom