User's Manual
Table Of Contents
- About this User Guide
- Table Of Contents
- Chapter 1– Setting Up And Administering The Switch
- Chapter 2 - Configuring MAC Address Management
- Chapter 3 – Configuring the Ports
- Chapter 4 – Configuring VLANs
- Chapter 5 – Configuring Class of Service
- Chapter 6 – Configuring Rapid Spanning Tree
- Chapter 7 – Configuring Multicast Filtering
- Chapter 8 – Diagnostics
- Chapter 9 – Using Ethernet And RMON Statistics
- Introduction
- View Ethernet Statistics
- View Ethernet Port Statistics
- Remote Monitoring (RMON)
- RMON Historical Statistics Concepts And Issues
- RMON Alarms And Events Concepts And Issues
- The Alarm Process
- Alarm Generation And Hysteresis
- Delta vs. Absolute Values
- Configure RMON Alarms
- Configure RMON Events
- RMON Event Logs
- Troubleshooting
- Chapter 10 - Using The CLI Shell
- Chapter 11 – Upgrading Firmware And Managing Configurations
- Appendix A - Menu Tree
- Appendix B - SNMP MIB Support
- Appendix C – SNMP Trap Summary
- Appendix D – RMON Acceptable MIB Parameters
- Index
RuggedSwitch™ User Guide
The main menu Port Configuration and Status command presents this menu.
Commands are provided to reset, configure and obtain the status of ports.
Figure 12: Port Configuration And Status Menu
My Switch Port Configuration and Status Admin Access
Configure Port Parameters
Configure Port Rate Limiting
Configure Port Security
Configure Port Mirroring
View Port Status
Reset Port(s)
<CTRL> Z-Help S-Shell
Port Parameter Ranges & Default Settings
The following set of tables lists default per-port configuration parameters
Configuration Item Default Value Supported Values
Status Enabled Disabled, Enabled
Media Type (10/100BaseT) Auto Select Auto Select, 10TX Half, 10TX Full, 100TX
Half, 100TX Full
Media Type (10BaseFL) 10BaseFL Full 10BaseFL Half, 10BaseFL Full
Media Type (100BaseFX) 100BaseFX Full 100FX Half, 100FX Full
Flow Control Enabled Disabled, Enabled
FEFI Disabled Disabled, Enabled
Broadcast Rate 2000 /sec 100 to 2000 /sec, Disabled
Port Security Disabled Disabled, Enabled, Learn Single
Link Alarms Enabled Disabled, Enabled
RuggedCom