User's Manual
Table Of Contents
- About this User Guide
- Table Of Contents
- Chapter 1– Setting Up And Administering The Switch
- Chapter 2 - Configuring MAC Address Management
- Chapter 3 – Configuring the Ports
- Chapter 4 – Configuring VLANs
- Chapter 5 – Configuring Class of Service
- Chapter 6 – Configuring Rapid Spanning Tree
- Chapter 7 – Configuring Multicast Filtering
- Chapter 8 – Diagnostics
- Chapter 9 – Using Ethernet And RMON Statistics
- Introduction
- View Ethernet Statistics
- View Ethernet Port Statistics
- Remote Monitoring (RMON)
- RMON Historical Statistics Concepts And Issues
- RMON Alarms And Events Concepts And Issues
- The Alarm Process
- Alarm Generation And Hysteresis
- Delta vs. Absolute Values
- Configure RMON Alarms
- Configure RMON Events
- RMON Event Logs
- Troubleshooting
- Chapter 10 - Using The CLI Shell
- Chapter 11 – Upgrading Firmware And Managing Configurations
- Appendix A - Menu Tree
- Appendix B - SNMP MIB Support
- Appendix C – SNMP Trap Summary
- Appendix D – RMON Acceptable MIB Parameters
- Index
Chapter 9 - Using Ethernet And RMON Statistics
Chapter 9 – Using Ethernet And RMON Statistics
Introduction
This chapter familiarizes the user with:
• Viewing Ethernet Statistics
• Viewing and Clearing Ethernet Port Statistics
• Configuring RMON History Control
• Viewing RMON History Samples
• Configuring RMON Alarms
• Configuring RMON Events
• Viewing RMON Event Logs
The Ethernet Statistics menu is accessible from the main menu Ethernet
Statistics command.
Figure 51: Ethernet Statistics Menu
My Switch Ethernet Statistics Admin Access
View Ethernet Statistics
View Ethernet Port Statistics
Clear Ethernet Port Statistics
Configure RMON History Controls
Configure RMON Alarms
Configure RMON Events
<CTRL> Z-Help S-Shell
RuggedCom
77