User's Manual

14
Getting Started
Chapter 2. Getting Started
This section provides an outline of the steps necessary to setup a new PA501. A detailed
guide follows the listed items, see as follows.
For additional technical assistance, contact your RuggON representative. See “Contacting
RuggON” on page 30.
It is recommended to installing or remove accessorie
s on a clean, well-lit work surface. To protect
yourself and the device from electrostatic discharge, wear anti- static wrist straps or place the device on
an anti-static mat.
First Time Use
PA501 is under “Battery Ship Mode” and will not power on to preserve the battery and prevent
power loss. To enable “Regular Mode” and activate the battery, please connect the power
adapter to power on.
Charging the Battery
When you use the AC adapter to connect your PA501 to a power outlet, the standard and
external (optional) battery will automatically begin to recharge.
While the battery is charging, the power LED will be active. When the battery is fully charged, the
power LED is lit a solid green.
1. Flip open the DC-IN cover to expose the DC-IN jack.
Opening the DC-IN Cover