User's Manual

50
Operation
Removing the Module
1. Power off the PM-311B. See “Powering Off the Device” on page 20.
2. Remove the screws securing the module.
Figure 75. Removing the Screws
3. Grasp the module from both sides and gently pull the module off.
4. Remove the module.
Figure 76. Removing the Module
5. Replace the snap-on module connector cover. See “Replacing the Snap-on Module
Connector Cover” on page 32.
Connecting to a Wireless Network
Before you can make use of the PM-311B wireless functions, you need to connect to a network.
The following is a set of procedures for connecting to a wireless network.
1. Before beginning, make sure your Wi-Fi setting is enabled and you are within range of a
wireless network. If your Wi-Fi setting is disabled, proceed to step 2.
 Find the network icon located on the right side of the taskbar. If the icon displays an X in
a red circle, you are not within range of a wireless network. Move to a different spot until
the Wi-Fi icon changes status indicating availability to a wireless network.
2. From any screen, open the Charms bar by sliding your nger inward from the screen’s right
edge. The Charms bar displays along the screen’s right side.
3. In the Charms bar, tap Settings to open the Settings menu.