Owner's Manual

Controlling

4-1

CONTROLLING

Battery Installation in the RCU

A new battery has been packaged inside the plastic bag with the

power cord. Before using the RCU, install the battery first.

Remove the battery cover on the backside of the RCU by pushing the

indicated handle a little to the bottom of the RCU. Lift the top side of

the cover at the same time (fig. 1).

Insert the new 9V battery (type 6F22S or equivalent; alkaline batteries

are recommended) in the lower compartment and connect the battery

to the contact plate.

Insert the battery into the lower compartment and put the cover back.

310a.DRW

fig.2

Battery

Contact

plate

Insert here

(behind the

plastic cover)

the 'Insert card

for RCU'.

Caution: Do not display a stationary image with full brightness

and contrast for longer than 20 minutes, otherwise you risk

damage to the CRTs.

fig.1