Owner's Manual

Random Access Adjustment Mode
6-14
Vertical Linearity Adjustment
The vertical linearity adjustment function corrects for vertical non-
linearities that extend from the center of the image to the top and
bottom of the image. Push the control disk up or down to highlight
V LINEARITY on the Geometry Menu and then press ENTER.
ENTER will select Vertical Linearity Adjustment
EXIT returns to Random Access Adjustment Mode Menu
ADJUST returns to Operational Mode
Adjust the vertical linearity with the control disk until the distances
between the horizontal lines of the set up pattern are equal from top
to bottom.
EXIT will return to the Geometry Menu.
Vertical Size Adjustment
Push the control disk up or down to highlight V SIZE on the Geometry
Menu and then press ENTER.
ENTER will select Vertical Size Adjustment
EXIT returns to Random Access Adjustment Mode Menu
ADJUST returns to Operational Mode
Adjust the vertical size by pushing the control disk up or down until the
correct image height is obtained.
Note :
- if the internal # pattern was selected, this pattern remains on the
screen.
- if the genlocked pattern was selected, the external source will be
displayed.
A bar scale and a numeric indicator will give a visual indication of the
vertical size adjustment.
EXIT will return to the Geometry Menu.
Image too
Tall
Image too
Short
Ideal
Image
Hight
Ideal
Image
Hight
GEOMETRY
H PHASE
RASTER SHIFT
LEFT-RIGHT (E-W)
LEFT SIDE CORRECTION
TOP-BOTTOM (N-S)
H SIZE
V LINEARITY
V SIZE
BLANKING
V LINEARITY
70
Select with or
then <ENTER>
<EXIT> to return.
GEOMETRY
H PHASE
RASTER SHIFT
LEFT-RIGHT (E-W)
LEFT SIDE CORRECTION
TOP-BOTTOM (N-S)
H SIZE
V LINEARITY
V SIZE
BLANKING
V SIZE
70