Owner's Manual

Random Access Adjustment Mode
6-15
Select with or
then <ENTER>
<EXIT> to return
BLANKING
TOP
BOTTOM
LEFT
RIGHT
Blanking Adjustments
Blanking adjustments affect only the edges of the projected image and
are used to frame the projected image on to the screen and to hide or
black out unwanted information (or noise). A 0% on the bar scale
indicates no blanking.
To start up the Blanking adjustments, follow the next procedure:
Push the control disk up or down to highlight BLANKING on the
Geometry Menu and then press ENTER.
The following blanking corrections are possible:
- top blanking
- bottom blanking
- left blanking
- right blanking
Therefore:
- if the internal # pattern was selected, this pattern remains on the
screen.
- if the genlocked pattern was selected, the external source
will be displayed.
Adjust the next blanking alignments until the image is correctly framed
or the unwanted information is blanked out. To enter a blanking
alignment, push the control disk up or down to highlight a function and
press ENTER to activate this function.
Press EXIT to return.
Adjustment of the blanking on the left side
Adjustment of the blanking on the right side
Adjustment of the blanking on the top of the image
Correct by pushing the control disk up or
down
Adjustment of the blanking on the bottom of the image
Correct by pushing the control disk to the
right or to the left
Select with or
then <ENTER>
<EXIT> to return.
GEOMETRY
H PHASE
RASTER SHIFT
LEFT-RIGHT (E-W)
LEFT SIDE CORRECTION
TOP-BOTTOM (N-S)
H SIZE
V LINEARITY
V SIZE
BLANKING
Select with or
then <ENTER>
<EXIT> to return
BLANKING
TOP
BOTTOM
LEFT
RIGHT
Top blanking
Left blanking Right blanking
Bottom blanking