Owner's Manual

Service Mode
7-7
G2 Adjust
This item is password protected. Highlight 'G2 Adjust' with the control
disk and press ENTER to continue. A safety notice will be displayed
on the screen since it is necessary to open the top cover to adjust the
G2.
G2 adjustment should be performed by Runco personnel or
Runco authorized dealers.
If you are qualified, press ENTER to continue. If not qualified, press
EXIT to return to the Service Mode Main Menu.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE MODE
G2 ADJUSTMENT
GAMMA CORRECTIONS
CRT RUN IN CYCLE
PROJECTOR WARM UP
CRT DRIVE MODE
MORE...
Gamma Corrections
This item is password protected. Highlight 'Gamma Corrections' with
the control disk and press ENTER to continue. A warning will be
displayed on the screen as there is a risk of incorrect adjustment of the
projector.
If you are qualified, press ENTER to continue. If not qualified, press
EXIT to return to the Service Mode Main Menu.
CRT Run in Cycle
The CRT Run in Cycle option can only be activated when memory
blocks on an internal # pattern are available. When one or more such
blocks are available, a flashing white image (5 sec on, 5 sec off) will
be generated or 5 minutes on the first internal block. In the next 5
minutes, a second internal block will be used to generate the flashing
white image. The image will also be shifted in a vertical way to prevent
a CRT burn in. To quit the CRT Run in Cycle option, press EXIT.
Highlight 'CRT Run in Cycle' with the control disk and press ENTER
to start.
If a memory block adjusted on an internal # pattern is available, the
CRT Run in Cycle will start when pressing ENTER. If no such block
is available, the projector cannot run the CRT Run In Option and
leaves the Adjustment Mode.
If you still want to run CRT Run In Cycle, first create a memory block
on an internal # pattern and restart the CRT Run In Option.
Select with or
then <ENTER>
<EXIT> to return.
SERVICE MODE
G2 ADJUSTMENT
GAMMA CORRECTIONS
CRT RUN IN CYCLE
PROJECTOR WARM UP
CRT DRIVE MODE
MORE...
Select with or
then <ENTER>
<EXIT> to return.
SERVICE MODE
G2 ADJUSTMENT
GAMMA CORRECTIONS
CRT RUN IN CYCLE
PROJECTOR WARM UP
CRT DRIVE MODE
MORE...
SAFETY
NOTICE
RISK OF ELECTRICAL SHOCK
G2 ADJUSTMENT SHOULD BE
PERFORMED BY RUNCO
PERSONNEL, OR RUNCO
AUTHORIZED DEALERS.
IF QUALIFIED, PRESS
<ENTER> TO CONTINUE, OR
IF NOT, <EXIT> TO RETURN
WARNING
RISK OF INCORRECT
ADJUSTMENT OF THE PROJECTOR
THE GAMMA CORRECTIONS ARE
FACTORY ADJUSTED USING AN
ACTAS COLOUR ANALYSER!
THEREFORE, ONLY QUALIFIED
INSTALLATION OR SERVICE
PERSONNEL SHOULD PERFORM
THESE ADJUSTMENTS !
<ENTER> TO CONTINUE
<EXIT> TO RETURN
CRT RUN IN CYCLE
A flashing white pattern will be
generated until <EXIT> is pressed.
The projector only uses memory
blocks adjusted on an internal
# pattern; if no such block is
available, the projector can't run
the procedure and leaves the
adjusment mode.
<ENTER> to continue
<EXIT> to cancel