User manual
Table Of Contents
- THREE YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Connections to the PlasmaWall and DHD Controller
- 4. Operation
- 4.1 Turning on the Power
- 4.2 Selecting the Input Source
- 4.3 Setting the Computer Display Properties
- 4.4 Using the On-Screen Menus
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
- Appendix A. PlasmaWall Service Remote Control
![](/manual/runco/flat-panel-television-sp-42dhd-sp-42dhdxa/user-manual-english/images/img-33.png)
Installation
24 PlasmaWall SP Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Digital Video Connection: The PlasmaWall has a DVI input, labeled DIGITAL RGB.
Connect the DVI output from the DHD Controller to this input, using a standard DVI cable.
RGBHV Connection: Connect the RGBHV output from the DHD Controller to the
ANALOG RGB IN input on the PlasmaWall. Use a standard, RGBHV breakout cable with
five BNCs at the DHD end and a 15-pin, D-sub male connector at the PlasmaWall end.
RS-232 Connection: Connect the RS-232 output from the DHD Controller to the
RS-232C input on the PlasmaWall. Use a standard, modular telephone cable with RJ11
plugs at both ends. On the PlasmaWall end, use the provided RJ11-to-DB9 adapter. This
adapter is wired as shown in
Figure 3-4.
Figure 3-4. RS-232 Connection from the DHD Controller to the PlasmaWall
3
4
2, 5
XMT DATA
RCV DATA
REQUEST TO SEND
SIG GND
3
2
8
7
5
RCV DATA
XMT DATA
CLEAR TO SEND
NO CONNECTION
1, 6
1, 9
SIG GND
To/From
DHD
Controller
PlasmaWall
RJ-11 Male
DB-9 Female
1 5
6 9
RS-232C