User manual
Table Of Contents
- THREE YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Connections to the PlasmaWall and DHD Controller
- 4. Operation
- 4.1 Turning on the Power
- 4.2 Selecting the Input Source
- 4.3 Setting the Computer Display Properties
- 4.4 Using the On-Screen Menus
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
- Appendix A. PlasmaWall Service Remote Control
Installation
PlasmaWall SP Series Owner’s Operating Manual 29
PRE
L
IMINAR
Y
RS-232 Controller
Connection
Use a standard, 9-pin RS-232 cable to connect a PC or home theater control/automation
system (if present) to the RS-232 Control port on the DHD Controller; see
Figure 3-9.
For more information about using this connection, refer to Serial Communications on
page 53.
Figure 3-9. RS-232 Control System Connection
Connecting 12-Volt
Trigger Outputs to
External Equipment
If your home theater contains equipment that responds to 12-Volt triggers, connect it to
the 12-Volt trigger outputs as shown in
Figure 3-10.
Figure 3-10. Connecting 12-Volt Trigger Outputs
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 OutComponent Video
1
2
345
7
89
6
to Automation/
Control System
or PC
2 Transmit Data
3 Receive Data
5 Ground
(none of the other pins are used)
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 OutComponent Video
to 12-Volt
trigger-activated
equipment
3.5-mm
mini plug
Tip = +12V
Sleeve = Ground