User manual
Table Of Contents
- THREE YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Connections to the PlasmaWall and DHD Controller
- 4. Operation
- 4.1 Turning on the Power
- 4.2 Selecting the Input Source
- 4.3 Setting the Computer Display Properties
- 4.4 Using the On-Screen Menus
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
- Appendix A. PlasmaWall Service Remote Control
Installation
30 PlasmaWall SP Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Cable Management To minimize cable clutter, you can use the cable ties provided with the PlasmaWall to
bundle the video, control and power cables at the back of the display. Install the cable ties
as shown in
Figure 3-11. Cables can be routed to the right or left.
Figure 3-11. Installing the Cable Ties
➤
Do not allow excessive stress to be placed on the ends of cables.
Note
* As viewed from the rear of the display.