User manual

Controls and Functions

Runco LS-1 Installation/Operation Manual 11

PRE

IMINAR

5. Aspect Ratio Selection Button

Press this button repeatedly to select one of the following aspect ratios:

16 : 9: For viewing 16:9 DVDs or HDTV programs in their native aspect ratio.

Letterbox: For viewing LaserDisc movies or non-anamorphic DVDs on a 16:9

screen.

4 : 3: Scales the input signal to fit 4:3 sources in the center of the screen.

4:3 Narrow: Scales the input signal to fit 4:3 sources in the center of the screen when

using an anamorphic lens.

Native: Displays source image in its native resolution without re-sizing or overscan.

6. MENU

Press this button to show or hide the OSD controls.

7. Memory Preset Buttons (M1 / M2 / M3)

Press to recall settings for the current input from one of three memory presets. By

default, these buttons are assigned as follows: M1 = User Memory

1; M2 = User

Memory

2; 3 = ISF Night. However, you can assign each button to any memory

preset you wish.

8. Picture Adjustment Buttons:

Contrast

Press to adjust white level.

Brightness

Press to adjust black level.

Sharpness (SHARP)

Press to adjust sharpness.

Gamma (GAMMA)

Press to select a gamma curve.

Overscan (OS)

Press to select an overscan mode.

Noise Reduction (NR)

Press to adjust noise reduction level.

9. LIGHT

Press momentarily to activate remote backlighting. Press and hold for five (5) seconds

to illuminate the projector rear panel, to facilitate connecting cables in a dark room.

10. Picture-In-Picture (PIP) Controls:

PIP

Press repeatedly to activate/deactivate PIP mode or select the desired PIP image

source.

SWAP

Press to swap the PIP image with the active source image.