User manual

Operation
Runco LS-1 Installation/Operation Manual 45
PRE
L
IMINAR
Y
4.1
Selecting Video
Memory
Press M1, M2 or M3 to recall settings from a memory preset. Then, press ENTER to
confirm your selection. Or, to cancel the operation, press
to select Cancel and press
ENTER.
You can assign each of these three buttons to any of four
memory presets. For more information, refer to
M1 Key /
M2 Key / M3 Key on page 67.
4.2
Selecting an Aspect
Ratio
Press the aspect ratio ( ) button to select the appropriate aspect ratio for the type of
program material being viewed.
4.3
Selecting An Input
Source
When you turn on the LS-1, it switches to the last
selected input and looks for a valid signal.
Use these buttons on the remote control to select an
input source directly. You can assign each of these five
buttons to any input. The default assignments are:
1
= HDMI 1, 2 = HDMI 2, 3 = Component, 4 = S-Video,
5
= Video.
For more information, refer to 1 Key / 2 Key / 3 Key / 4 Key / 5 Key on page 67.
4. Operation
M1 M2 M3
SHARP
USER MEMORY
1
4
2 3
5
▲
SOURCE