- RUNCO OWNER'S OPERATING MANUAL Flat Panel Plasma Display Monitor PL-43DHD, PL-50DHD

PlasmaWall Service Remote Control
Runco PL-43DHD and PL-50DHD Owner’s Operating Manual A-3
Figure A-2. PlasmaWall Setup Menu
Video NR (Noise
Reduction)
To change the Noise Reduction setting on INPUT 1:
1. Press 1 to switch to PlasmaWall INPUT 1.
2. Press MENU on the PlasmaWall Service Remote Control.
3. Press or to select SETUP.
4. Press to select VIDEO NR, then press SET.
5. Press or to select the desired amount of noise reduction (OFF, LOW, MIDDLE or
HIGH).
6. Press SET to confirm your selection.
MPEG FilterTo change the MPEG Filter setting on INPUT 1:
1. Press 1 to switch to PlasmaWall INPUT 1.
2. Press MENU on the PlasmaWall Service Remote Control.
3. Press or to select SETUP.
4. Press to select MPEG FILTER, then press SET.
5. Press or to select the desired amount of filtering (OFF, LOW, MIDDLE or HIGH).
6. Press SET to confirm your selection.
SET
MENU
MIDDLE
:
:
VIDEO NR
MIDDLE
:
MPEG FILTER
ON
:
CHROMA EE
OFF
:
CINEMA MODE
RGB
:
COLOR SPACE
AUTO
:
CLAMP POSITION
750p
:
SIGNAL
COLOR TEMP.
:
MIDDLE
AUTO POWER OFF DISABLE
PLASMAWALL INPUT1
CHANGE EXIT
PICTURE SCREEN SETUP OPTION