User manual

Installation
20 Runco CL-410 and CL-420 Owner’s Operating Manual
3.4
Connections to the
CL-410/CL-420
Proceed as follows to connect the CL-410/CL-420 to your video sources, external
controller(s) -- if present -- and AC power.
When connecting your equipment:
• Turn off all equipment before making any connections.
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connector Panel Access To access the connector panel, pull firmly on the cable access cover to open it.
Connecting the
CL-410/CL-420 to Source
Components
Connect your video sources to the CL-410/CL-420 as shown and described in the
sections that follow.
HDMI Connections: The CL-410/CL-420 has an HDMI input for connecting a DVD
player, DTV decoder, personal computer or any other device with a DVI or HDMI output.
Connect such devices as shown in
Figure 3-7.
➤
➤
Use the HDMI input whenever possible. This ensures the highest
video quality because the signal is carried in the digital domain
throughout the entire signal path, from source component output
into the projector.
To connect a DVI component, use the DVI-to-HDMI adapter and
cable provided with the projector.
The CL-410/CL-420 supports the VESA Display Data Channel (DDC)
standard. This standard provides “Plug and Play” capability; the
projector and a VESA DDC-compatible computer communicate their
setting requirements, allowing for quick and easy setup.
In order for Plug and Play to work correctly, you must turn on the
projector before you turn on the connected computer.
Tip
Note