User manual

Runco CL-410 and CL-420 Owner’s Operating Manual 27

4.1

Turning on the Power

1. Turn on your source components.

2. Plug the female end of the power cord into the

AC receptacle on the rear of the

CL-410/CL-420 (AC 100V ~ 240V).

3. Connect the other end to your AC power

source. The power indicator lights blue to

indicate that the CL-410/CL-420 is in

“standby” mode.

4. Press the ON button on the remote control to

turn on the projector. The power indicator

turns off.

5. After a brief warm-up period (approximately 10

seconds), the CL-410/CL-420 will start projecting.

4.2

Adjusting the

Projector Height or

Projection Angle

When the CL-410/CL-420 is installed upright, you can adjust the projector height or

projection angle by turning the four adjustable feet on the bottom of the projector; see

Figure 4-1. This is useful for correcting the angle of projection when the projector is placed

on an uneven surface or when the screen is at an angle. You can tilt the projector up to

five (5) degrees up or down by adjusting the feet.

The feet are connected to threaded bolts; turn them clockwise to raise the projector or

counterclockwise to lower it.

Figure 4-1. Adjusting the Feet

4. Operation

Tilting the projector may cause keystone distortion. To correct this,

refer to

Keystone Correction on page 43.

Note

Adjustment feet

5° max.