User manual

Operation
44 Runco CL-410 and CL-420 Owner’s Operating Manual
ISF Settings Use the ISF Settings menu to perform advanced picture quality adjustments. This menu
should be used by ISF-certified technicians only.
Several controls in this menu are identical to those in the Picture Adjust menu, but are
accessible only by entering the ISF Calibration menu passcode. This makes it possible to
restore the picture quality settings to what they were when the projector was installed,
simply by recalling the “ISF Night” or “ISF Day” preset.
Brightness: Refer to Brightness on page 35.
Contrast: Refer to Contrast on page 36.
Color: Refer to Color Saturation on page 36.
Tint: Refer to Tint on page 37.
Sharpness: Refer to Sharpness on page 38.
Gamma: Refer to Gamma on page 38.
Color Temp: Refer to Color Temperature on page 39.
Picture Setting: To recall the Custom1, ISF Night or ISF Day settings, choose Picture
Setting from the ISF Calibration menu. Then, select “Custom1,” “ISF Night” or “ISF Day”
and press ENTER, or use the corresponding buttons on the remote control.
White Balance: Refer to White Balance on page 40.
Save Settings: For each input and supported resolution, the CL-410/CL-420 lets you
save image quality settings as presets that you can recall at a later time. You can create
up to three presets -- designated “Custom1,” “ISF Day” and “ISF Night” -- per input and
resolution.
You should save changes to any of the following settings to a preset; otherwise they will
be lost when a new input source or resolution is selected:
• Aspect ratio
• Picture adjustments (brightness, contrast, color saturation, tint, sharpness, gamma,
color temperature, ICC selection and white balance settings)
• Image options (SDTV adjust settings, brightness enhance, lamp power)
To save image settings in the “ISF Day” or “ISF Night” preset, select Save Settings from
the ISF Calibration menu and select “ISF Day” or “ISF Night.” (To save settings to the
“Custom1” memory preset, refer to
Save Settings on page 40.)
Lamp Timer Reset: When you replace the projector lamp, you should also reset the
lamp hour counter. To do this, select Lamp Timer Reset from the ISF Calibration menu
and press ENTER. The CL-410/CL-420 shows the number of hours the projector lamp
has been in service and asks you to confirm or cancel the reset. Press ENTER to confirm
or EXIT to cancel.
For detailed lamp replacement instructions, refer to Lamp Replacement on page 50.
ISF Calibration
Brightness 0
Contrast 0
Color 0
Tint 0
Sharpness 3
Gamma 2.2
Color Temp 6500K
Picture Setting
White Balance
Save Settings
Lamp Timer Reset
ICC Adjust Standard
ISF Enable OFF
Blue Enable OFF
Splash Screen Timer 60 secs
Noise Reduction 0
➤
You must enter a passcode to access the ISF Settings menu.
Note