Specifications

Installation
Q-750d Ultra Series Installation/Operation Manual 43
PRE
L
IMINAR
Y
3.8
Turning on the Power
1. Turn on your source components.
2. Turn on the main power switch at the rear of the DHD Controller.
3. If this is an AutoScope-equipped projector, turn on the main power switch at the rear
of the AutoScope lens motor. The lens motor power switch is located next to the AC
input.
4. Press the ON button on the remote control (or the ON/STANDBY ( ) button on
DHD Controller front panel) to turn on the system. The vacuum fluorescent display on
the DHD Controller front panel briefly displays “Initializing System,” followed by
“Starting Q-750d Ultra.” On the projector, the LED flashes green to indicate that it is
warming up.
5. When the projector is ready for use, the LED turns off. On the DHD Controller, the
fluorescent display indicates the active source, input resolution/frame rate and aspect
ratio/screen; for example:
HDMI 1
16:9/1 1080i/60
Current
Source
Aspect Ratio/Screen
Input Resolution/Frame Rate
Q-750d
1080p/60