- RUNCO International OWNER'S OPERATING MANUAL 1080p Digital Light ProcessingTM Projector and Digital High Definition (DHDTM) Controller VX-44d, VX-55d
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Projection Lens
- 3.5 Installing the Optional CineWide Lens Mount
- 3.6 Mounting the VX-44d/-55d
- 3.7 Connections to the VX-44d/-55d and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-44d/-55d
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Outputs to External Theater Equipment
- Connecting an External IR Receiver to the DHD Controller
- Connecting to AC Power
- 3.8 Turning on the Power
- 3.9 Adjusting the Picture Orientation
- 3.10 Primary Lens Adjustments
- 3.11 Installing and Adjusting the CineWide Anamorphic Lens
- 3.12 Calibrating Projector Input 2 (DVI)
- 3.13 Working With the Lamp
- 4. Operation
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
Runco VX-44d/-55d Owner’s Operating Manual 95
PRE
L
IMINAR
Y
7.1
VX-44d/-55d
Specifications
Table 7-1 lists the VX-44d/-55d specifications.
7. Specifications
Table 7-1. VX-44d/-55d Specifications
Projector Type: Digital Light Processing (DLP), 3-chip, 16:9 SuperOnyx DMD
Native Resolution: 1920 x 1080 (16:9)
Aspect Ratios: Refer to Table 7-2
Video Standards: Refer to Table 7-2
DTV Compatibility: 480p, 720p, 1080i, 1080p
Scan Frequency: Horizontal: 15 kHz to 120 kHz
Vertical: 23.97 Hz to 150 Hz
Picture Size (16:9 Screen): VX-44d:
Recommended width = 72 to 192 in.
Maximum width = 300 in.
VX-55d:
Recommended width = 72 to 240 in.
Maximum width = 350 in.
Throw Distance
(Factor x Screen Width):
Refer to Table 3-3
Horizontal and Vertical
Offset:
Refer to Table 3-4
Lamp: VX-44d: 1,000 Watt Xenon lamp module
VX-55d: 1,200 Watt Xenon lamp module
Estimated Lamp Life: 1,000 hours
Inputs: (1) DVI-I with HDCP (from DHD Controller)
(1) RS-232 (from DHD Controller)
Controls: - Built-in keypad
- IR remote
- Serial commands via RS-232 (from DHD Controller)