- RUNCO International OWNER'S OPERATING MANUAL 1080p Digital Light ProcessingTM Projector and Digital High Definition (DHDTM) Controller VX-44d, VX-55d
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Projection Lens
- 3.5 Installing the Optional CineWide Lens Mount
- 3.6 Mounting the VX-44d/-55d
- 3.7 Connections to the VX-44d/-55d and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-44d/-55d
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Outputs to External Theater Equipment
- Connecting an External IR Receiver to the DHD Controller
- Connecting to AC Power
- 3.8 Turning on the Power
- 3.9 Adjusting the Picture Orientation
- 3.10 Primary Lens Adjustments
- 3.11 Installing and Adjusting the CineWide Anamorphic Lens
- 3.12 Calibrating Projector Input 2 (DVI)
- 3.13 Working With the Lamp
- 4. Operation
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
Installation
18 Runco VX-44d/-55d Owner’s Operating Manual
PRE
L
IMINAR
Y
3.2
Quick Setup
Table 3-1 gives a quick overview of the VX-44d/-55d installation process. The sections
following this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer to
page...
1 Choose a location for the projector 19
2 Install primary projection lens 25
3 Install CineWide lens mounting assembly (stationary base
plate or AutoScope lens motor – optional)
26
4 Mount the projector 28
5 Connect the DHD Controller to the projector 29
6 Connect signal sources to the DHD Controller 30
7 Connect external controller to RS-232 port (optional) 34
8 Connect other home theater components to 12-volt trigger
outputs (optional)
34
9 Apply power to the projector 36, 37
10 For rear-screen and/or ceiling-mount installations, select
the proper picture orientation
38
11 Primary lens adjustments: projected image size (zoom),
position (shift) and focus
21, 38
12 Install CineWide anamorphic lens (optional) 39
13 CineWide lens adjustments: projected image size (zoom),
position (shift) and focus
40
14 Calibrate projector input 2 (DVI): perform Auto Setup, then
adjust size/position, input levels, brightness/contrast etc.,
as needed for each channel
44
15 Adjust lamp output and optical aperture, as needed 58
16 DHD Controller input calibration: adjust the following for
each DHD Controller input; save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position
63 through 71
Note