- RUNCO International OWNER'S OPERATING MANUAL 1080p Digital Light ProcessingTM Projector and Digital High Definition (DHDTM) Controller VX-44d, VX-55d
Table Of Contents
- TWO YEAR LIMITED WARRANTY
- Safety Precautions
- 1. Introduction
- 2. Controls and Functions
- 3. Installation
- 3.1 Remote Control
- 3.2 Quick Setup
- 3.3 Installation Considerations
- 3.4 Installing the Projection Lens
- 3.5 Installing the Optional CineWide Lens Mount
- 3.6 Mounting the VX-44d/-55d
- 3.7 Connections to the VX-44d/-55d and DHD Controller
- Connector Panel Access
- Connecting the DHD Controller to the VX-44d/-55d
- Connecting Source Components to the DHD Controller
- RS-232 Controller Connection
- Connecting 12-Volt Trigger Outputs to External Theater Equipment
- Connecting an External IR Receiver to the DHD Controller
- Connecting to AC Power
- 3.8 Turning on the Power
- 3.9 Adjusting the Picture Orientation
- 3.10 Primary Lens Adjustments
- 3.11 Installing and Adjusting the CineWide Anamorphic Lens
- 3.12 Calibrating Projector Input 2 (DVI)
- 3.13 Working With the Lamp
- 4. Operation
- 5. Maintenance and Troubleshooting
- 6. Serial Communications
- 7. Specifications
![](/manual/runco/runco-video-xtreme-vx-55d/runco-international-owners-operating-manual-1080p-digital-light-processingtm-projector-and-digital-high-definition-dhdtm-controller-vx-44d-vx-55d/images/img-45.png)
Installation
34 Runco VX-44d/-55d Owner’s Operating Manual
PRE
L
IMINAR
Y
RS-232 Controller
Connection
Use a straight-through, 9-pin RS-232 cable to connect a PC or home theater
control/automation system (if present) to the RS-232 Control port on the DHD Controller;
see
Figure 3-13.
For more information about using this connection, refer to Serial Communications on
page 89.
Figure 3-13. RS-232 Control System Connection
Connecting 12-Volt
Trigger Outputs to
External Theater
Equipment
If your VX-44d/-55d is equipped with a CineWide with AutoScope system, connect the
AutoScope lens motor to a 12-volt trigger output on the DHD Controller; see
Figure 3-14.
Similarly connect other 12-volt trigger-activated equipment (such as retractable screens or
screen masks) to the other trigger outputs.
➤
Pb Pr Y
Video
3
IR
RS-232 Control
S-Video 1
S-Video 2
1
2
TRIGGERS
RS-232 OutComponent Video
1
2
345
7
89
6
to Automation/
Control System
or PC
2 Transmit Data
3 Receive Data
5 Ground
(none of the other pins are used)
➤