Installation guide

Runco WindowWall Installation Guide 49
Configuring a Runco
WindowWall
Menu Settings
There are four different menu settings that are available when you open the on-
screen menus: navigational, global, local and status. These will be described in more
detail on the following pages.
Basic Configuration Steps
Configure your displays when you perform steps in the following order:
1 Runco WindowWall Layout (global) - see "Matrix Layout Menu" on page 59.
2 Color Balance the displays (local) - see "Adjusting Color Balance" on page 61.
3 Configure Wall Settings. See "Understanding Wall Configuration" on page 101 for
more information.
4 If you need to adjust the image, see "On-Screen Menus" on page 119 to see
different menu options.
Master vs. Slave Displays
The master display is the LCD where the bulk of the on-screen menu configuration
and off-board configurations will be controlled. The master display is the one
plugged into the LCD 1 connector of Quad Input Manager Module A, which is
identified on screen as A1. All other displays in the array are considered “slave”
displays, which will receive many global software and hardware commands from the
master (A1). Information specific to individual displays can be controlled on slave
displays.