User's Manual
CPE-O-R-WS User Manual
16 Runcom Technologies Ltd.
4 Managing CPE Devices
4.1 General
Configuration of any field should be followed by “apply”
When changes in a page are finished, the “save settings” button should be pushed before leaving the page.
After all changes in the CPE configuration is done and saved, “reboot system” is required to guarantee proper
operation of the device.
4.2 Accessing CPE via Web Brower
Managing CPE requires access by Web browser from a local port or remote host via WiMAX network, for example,
Internet Explorer in Windows operation systems.
Two options are available to access the CPE by using the LAN interface or via the wireless network if its network IP is
known.
The default IP address for the LAN interface is 192.168.0.1, unless the configuration has been modified.
The IP address for the WAN interface is usually acquired from service provider’s network after CPE connects
to the network.
Two levels of managing CPE are available, Administrator and User.
Administrator’s privilege is designed for service providers to provision a CPE device before selling or leasing
out to end users. By supplying administrator’s user name and password, a technician has access to all
configurations of a CPE device. Default user name for administrator’s privileges is “admin”. Default password
is “admin”.
Users’ privilege is provisioned for end users to make limited changes of configurations for a CPE device. Most
of other configurations are not visible when accessed with normal user’s privileges. Default user name and
password for user is “user”.
4.2.1 Access CPE from LAN Segment
Connect the LAN port of Control Station (a PC) directly to the LAN port of the CPE, or in-indirectly via an Ethernet
hub or switch. By default, the CPE will act as a DHCP server for hosts in the LAN segment unless this feature is
disabled. The Control Station can dynamically acquire an IP address from CPE’s built-in DHCP server.
After IP layer connectivity is established between the Control Station and the CPE, the user may launch a Web browser
and specify http://192.168.0.1 in the address bar. A window will pop up requesting user name and password.
Input user name and password, and then click on the “OK” button. After a successful log on, the welcome page of web
management interface will appear.